Section 11 — Refractory, Insulation & Fireproofing
SECTION 11 REFRACTORY, INSULATION AND FIREPROOFING
IPE Engineering Practice IPE-EP-11-0-0
Document number: IPE-EP-11-0-0 · Section: 11 — Refractory, Insulation & Fireproofing
SECTION 11 REFRACTORY, INSULATION AND FIREPROOFING
TITLE ......................................................................................................................... EP REV
No. No.
Table of Contents................................................................................................11–0–0 1.0
Internal Insulating and Refractory Linings ..........................................................11–1–1 1.0
Internal Insulating and Refractory Linings Data Sheet ..................................11–1–1DS 1.0
Internal Insulating and Refractory Linings Inspection Checklist ...................... 11–1–1C 1.0
Fired Heater Refractory ......................................................................................11–1–2 1.0
Fired Heater Refractory Data Sheet ..............................................................11–1–2DS 1.0
Fired Heater Refractory Inspection Checklist .................................................. 11–1–2C 1.0
Supplemental Requirements for Refractory (Future Release) ...........................11–1–3 1.0
Fireproofing .........................................................................................................11–2–1 1.0
Fire Protection Shields for Wafer Valves ............................................................11–2–2 1.0
Insulation Design ................................................................................................11–3–1 1.0
Insulation Application – Piping ............................................................................11–3–2 1.0
Insulation Application – Vessels and Equipment ................................................11–3–3 1.0
Insulation Application – Tanks and Spheres.......................................................11–3–4 1.0
Insulation Application – Tanks and Spheres Data Sheet ..............................11–3–4DS 1.0
Removable/Reusable Insulation .........................................................................11–3–5 1.0
Insulation of Flanged Joints and Valves in Hot Service......................................11–3–6 1.0
© 2026 Inflection Point Engineering, LLC. All rights reserved. The content of this page — including calculation methods, reference data, written analysis, interactive tools, and source code — is the intellectual property of Inflection Point Engineering, LLC and is protected under applicable copyright, trademark, and trade secret laws. Unauthorized reproduction, redistribution, modification, or derivative use in whole or in part is prohibited without prior written consent.
Disclaimer. This material is provided for informational and educational purposes only and does not constitute professional engineering advice. Calculations, reference data, and methodologies are based on published standards and accepted engineering practice but are not a substitute for engineering judgment, site-specific analysis, or review by a licensed Professional Engineer. Inflection Point Engineering, LLC makes no warranties, express or implied, regarding the accuracy, completeness, or fitness for a particular purpose of any content presented here, and shall not be liable for any direct, indirect, incidental, or consequential damages arising from its use. Users assume all risk associated with applying this content to real-world design, operations, or decisions.
© 2026 Inflection Point Engineering, LLC. All rights reserved.