7-0-0

IPE Engineering Practice IPE-EP-7-0-0

Document number: IPE-EP-7-0-0 · Section: 7 — Pressure Vessels

SECTION 7 PRESSURE VESSELS

TITLE ......................................................................................................................... EP REV

No. No.

Table of Contents..................................................................................................7–0–0 1.0

Pressure Vessels ..................................................................................................7–1–1 1.0

Pressure Vessels Data Sheet ..........................................................................7–1–1DS 1.0

Pressure Vessels Inspection Checklist.............................................................. 7–1–1C 1.0

Pressure Vessels for Non–Process Services .......................................................7–1–2 1.0

Heavy Wall and Special Service Pressure Vessels..............................................7–1–3 1.0

Supplemental Requirements for Pressure Vessels ..............................................7–1–4 1.0

Welding Requirements for Pressure Vessels .......................................................7–1–5 1.0

Metal Lining and Cladding ....................................................................................7–1–6 1.0

Pressure Vessel Details........................................................................................7–1–7 1.0

Low Chrome Thick Walled Pressure Vessels

In High Temperature Hydrogen Service ..............................................................7–1–8 1.0

Pressure Vessel Internals .....................................................................................7–2–1 1.0

Fractionating Tray and Tower Packing .................................................................7–2–2 1.0

Fractionating Tray and Tower Packing Data Sheet .........................................7–2–2DS 1.0

Cyclone Systems for Fluid Catalytic Cracking Units.............................................7–2–3 1.0

Cyclone Systems for Fluid Catalytic Cracking Units Data Sheet.....................7–2–3DS 1.0

Pressure Vessel Internals Weld and Cleanliness Acceptance Criteria ................7–2–4 1.0

Rerating of Pressure Vessels ...............................................................................7–3–1 1.0

Repairs, Alterations and Fitness for Service of Pressure

Vessels (Future Release) .....................................................................................7–3–2 1.0

Repairs and Alterations to Flanges.......................................................................7–3–3 1.0

Addition of Nozzles to Existing Pressure Vessels (Future Release) ....................7–3–4 1.0

Repair to Existing Pressure Vessel Shells (Future Release) ...............................7–3–5 1.0

Post Weld Heat Treatment of Existing Pressure Vessels (Future Release) ........7–3–6 1.0

Field Installation of Weld Overlay to Existing Pressure

Vessels .....................................................................................7–3–7 1.0

Field Installation of Strip Lining to Existing Pressure Vessels (Future Release).7–3–8 1.0

Addition of Welded Internals to Existing Pressure Vessels (Future Release)......7–3–9 1.0

© 2026 Inflection Point Engineering, LLC. All rights reserved. The content of this page — including calculation methods, reference data, written analysis, interactive tools, and source code — is the intellectual property of Inflection Point Engineering, LLC and is protected under applicable copyright, trademark, and trade secret laws. Unauthorized reproduction, redistribution, modification, or derivative use in whole or in part is prohibited without prior written consent.

Disclaimer. This material is provided for informational and educational purposes only and does not constitute professional engineering advice. Calculations, reference data, and methodologies are based on published standards and accepted engineering practice but are not a substitute for engineering judgment, site-specific analysis, or review by a licensed Professional Engineer. Inflection Point Engineering, LLC makes no warranties, express or implied, regarding the accuracy, completeness, or fitness for a particular purpose of any content presented here, and shall not be liable for any direct, indirect, incidental, or consequential damages arising from its use. Users assume all risk associated with applying this content to real-world design, operations, or decisions.